Inductive probe for 3D printer Input voltage: 6-36V Model:LJ12A3-4-Z/BX 3 wires ( brown, blue, black) Output type: NPN NO (normaly open) Diameter of the blue probe: 10,5mm Diameter of the thread: 12mm Sensing distance: 4mm Current consumption: max 200mA Size: 5.8x 1.2cm Wire size: about 115cm Weight: 44g
Pack of 2 aluminum plates 3mm/2mm thick Laser cut 1 top plate (print surface) 435x320x3mm with 4 holes in the corners for screws1 bottom plate 435x320x2mm with 4 holes in the corners for screws 10 holes for bearing and belt supports
Heatbed Pack for Scalar XL 3D printer Contains 2 aluminum plates (3mm thick) laser cut with fixation holes 1 silicone heatter (700w-220V) 1 thermistor 1 static relay Free 1 set of nuts and bolts: 4 spacers 4 conic head screws 4 nuts for conic screws 10 M6x12mm screws 20 M3 washers 10 nylstop nuts
Heatbed Pack for Scalar S 3D printer Contains: 2 aluminum plates laser cut with fixation holes (1 top plate 3mm thick, 1 bottom plate 2mm thick) 1 silicone heatter (250W-220V) 1 thermistor 1 static relay + Wires Free: 1 set of nuts and bolts: 4 springs 4 conic head screws 4 nuts for conic screws 4 M6x12mm screws 4 M3 washers 4 nylstop nuts
Key features: Dual Drive System The bed will have 2 driving points on the sides of the bed instead of only 1 in the middle of it. Linear motion on 2020 aluminum extrusions Increases: The maximum payload (max weight of heatbed) Print quality Bed stabilityNo firmware change
This upgrade intends to add a 2nd stepper motor on the Y axis. This increase the stability of the belts of the dual drive system. It also reduces the vibrations on the belts.
0.4mm Stainless Steel Hot end nozzle for E3D Volcano 3D printer's Hot ends: Threading: M6 Nozzle diameter: 0.4mm Material: Stainless Steel Cone fine tip Compatible with E3DV6 Volcano 1.75mm hot end