S6000-2RS 10*26*8mm Axial ball bearing Stainless steel 440C (9Cr18)
This article contains: 1x Smart Adapter for Ramps 1.4 1x 5" LCD controler with SD card slot 2x 60cm long cables fprovided with push button cap
LCD Display IPS WaveShare compatible with Raspeberry pi B+/2B/3B/3B+ Resolution 480x320 Resitive Touch screen Can be plugged directly on Raspberry pi GPIO
The lightest performing extruder on the market Geniune Extrudeur Bondtech BMG Modele: BMG (right hand) For filament 1.75mm Dual-Drive technology
The lightest performing extruder on the market Geniune Extrudeur Bondtech BMG Modele: BMG (right hand) For filament 1.75mm Dual-Drive technology Compatible with CR-10 and CR-10S 3D printer
TFT 2.8" Touch screen compatible with Ramps 1.4 and MKS BASE Touch Screen SD card support USB key support Can be connected to a backup UPS Allows to resume print from power shortage Allows filament change during print
Expansion board for independant stepper motor drivers (57/86 stepper drives) Built in buffer chip (type 74HC04) Ideal to connect your MCU to any high current stepper motor drives This module is compatible with standard A4988, DRV8825 etc... stepper motor drivers pinout
Stepper Motor Driver based on a Trinamic TMC2100 with soldered pin headers
SPI Cable for 2 stepper drivers TMC2130 Compatible with the following boards Ramps 1.4 MKS Gen 1.4 MKS GEN LAllows to access advanced drivers functionalitiesstealthChop spreadCycle coolStep stallguard dcStep-load
Main caracteristics: 12V, 0.12A Brushless Format: 5015S Dimentions: 50x50x15mm Speed: 5700 rpm ±10% Airflow: 5 CFM
Extender wire 4 pins Dupont 20 cm wire length 1 Female-2 Male 3 connectors Great for splitting Nema 17 stepper motor wires