Twin Wire 24 AWG (diametre 0.5106mm,...
TL-Smoother, specially designed to smooth out and rectify the signal from 3D printer stepper motor drivers. Specially designed for DRV8825 Also compatible with other stepper motor drivers such as A4988, etc...
This pack contains 5 NEMA17 stepper motors compatible with Scalar 3D printers. Powerful, robust, with a nice capacity to stay cool thanks to it's 40mm high and limited 1.2A per phase; Uses only 1.2A for a 4000 g.cm torque (0.44 Nm ou 62 Oz.In) It contains: 5 motors with 1m lead wires and a 4 pin female dupont connector
Allows to drive Stepper motors. Max coil current: 2.2A More powerfull and more precise than the commonly used A4988 Needs a good air flow below the chip THe heatsink is optional if you have a good air flow, but needed in order to use the max current. Maximum resultion of 1/32 micro-steps supported by 8bit micro-controlers such as Atmega 2560.
This pololu A4988 stepper motor driver is installed in a very largme amount of DIY 3D printers. It can be considered as the reference stepper driver amount stepper drivers. Courant dmaximum de bobine: 1.75A Max avec dissipateur. Max Current per coil: 1.75A
Top idler specially designed to prevent wobbling of the Z lead screws Compatible with Creality CR-10 and Anet E10 3D printers Also compatible with any 3D printers using 8mm lead screws and 2020 extrusion profiles
Silent stepper motor driver TB67S109 Chipset Toshiba TB67S109 Max current 3.32A Micro stepping: 1/4, 1/8, 1/16, 1/32 Technologies: ADMD, Arrêt thermique (TSD), proctection contre les suintensités (ISD), remise sous tension (POR)