Large silicone heater for RepRap 3D...
Heatbed Pack for Scalar S 3D printer Contains: 2 aluminum plates laser cut with fixation holes (1 top plate 3mm thick, 1 bottom plate 2mm thick) 1 silicone heatter (250W-220V) 1 thermistor 1 static relay + Wires Free: 1 set of nuts and bolts: 4 springs 4 conic head screws 4 nuts for conic screws 4 M6x12mm screws 4 M3 washers 4 nylstop nuts
Large silicone heater for RepRap 3D printers Material: Silicone Size: 190x190mm Power: 250W Input Voltage: 220V Power supply cable length: 1 metre Back Tape: 3M Thermal fuse set at 140°C
Key features: Dual Drive System The bed will have 2 driving points on the sides of the bed instead of only 1 in the middle of it. Linear motion on 2020 aluminum extrusions Increases: The maximum payload (max weight of heatbed) Print quality Bed stabilityNo firmware change
Large silicone heater for RepRap 3D printers MAX 95°C (Thermal fuse set at 100°C) Material: Silicone Size: 190x190mm Power: 250W Input Voltage: 220V Power supply cable length: 1 metre Back Tape: 3M
Modular enclosure for 3D Scalar S 3D printer The enclosure is installed over the existing chassis Transparent acrylic doors doubles front doors with magnet stoppers Integrated air filtration Only compatible with Scalar S 20x20x20 print volume