[CR-10] Scalar electronic Upgrade for CR-10 3D Printer (TMC2208 edition)

CR-10_ELEC_UPGRADE_SCALAR_2208

New product

Boost your CR-10!

Scalar Electronic Upgrade for CR-10 3D printers

  • Power up your CR-10 using the modular design electronic box from the Scalar 3D printers
  • Improoved performances
  • Silent mode (including 2x TMC2208)
  • Supports a wide range of options (Dual extrusion, BLTouch, PS_ON, etc...)
  • 100% compatible with opensource Marlin firmware
  • Supports E3D hot ends.

More details

Available within 1-2 weeks

149,50 € tax incl.

Including 0,50 € for ecotax

More info

Key features

  • Evolutive electronic, already programmed, ready to use.
  • Compact box, cooled down, to be attached on the top of your chassis. Reduces your printer footprint.
  • Entirely modular electronic box.
  • Specially made to work with l'220V 600W heatbed upgrade, allowing to reduce the heat of the different elements
  • Removes the use of the original electronic box
  • Supports a wide range of  options:
  • Compatible with 32 bits Re-Arm controleur boards for future evolutions
  • Allows to easily change / replace existing stepper motor drivers
  • Compatible with a wide range of stepper motor drivers (4988, DRV8825, TMC2100, etc...)
  • Supports TL-Smoother
  • Unlocked Marlin firmware features
  • You can keep all the existing wiring
  • Optimised 8 bit controler performances

Additional information

  • Setup time, about 1 to 2h.

The kit contains

  • 1 Scalar electronic box, programmed to work with CR-10
  • Includes 2 TMC2208 on  X and Y axis, set up for 16 micro steps with 256 micro steps interpolation.(Steahchop2 function)
  • Hyper silent setup thanks to the TMC2208 drivers.
  • 1x 12V 10A 120W PSU
  • wire extenders
  • 1 kit of plastic parts
  • 1 twisted cable protection binding
  • 1 MicroSd adaptor

The kit doesn't contains

This kit Requires:

Important points

  • The CR-10 has been developped to use a separate electronic box. Some wiring path on the chassis are not optimised for this upgrade. This upgrade doesn't pretend to be optimised for the wiring on the CR-10.

  • This upgrade is specially fit to work with the 220V 600W heat bed upgrade.
  • If you still want to use the original 12V heatbed, make sure to reuse the internal Power mosfet and the Original Power supply for this purpose!
  • The provided power supply won't support to be used with the existing 12V heat bed!

  • This upgrade requires to remove wires from the original electronic box. It is mandatory to properly disconnect any power cable from the original electronic box before any operation

Documentation de montage

Disponible ici

Pack content

Reviews

No customer reviews for the moment.

Write a review

[CR-10] Scalar electronic Upgrade for CR-10 3D Printer (TMC2208 edition)

[CR-10] Scalar electronic Upgrade for CR-10 3D Printer (TMC2208 edition)

Boost your CR-10!

Scalar Electronic Upgrade for CR-10 3D printers

  • Power up your CR-10 using the modular design electronic box from the Scalar 3D printers
  • Improoved performances
  • Silent mode (including 2x TMC2208)
  • Supports a wide range of options (Dual extrusion, BLTouch, PS_ON, etc...)
  • 100% compatible with opensource Marlin firmware
  • Supports E3D hot ends.

Accessories