Warning: Last items in stock!
This sensor is to be placed at the entrance of your extruder
The filament has to go through the sensor box
When the filament is running out, the sensor will trigger.
The firmware will then trigger a filament change action
On Rumba boards, you will need to connect the module on AUX3 port on pins PWM_1 et GND
The changes presented here corresponds to Marlin RC8 firmware.
The procedure is similar with other version of marlin that supports this feature. Marlin RC8 and above are available for Scalar 3D printer. You will also find the procedure to upgrade your firmware.
You first need to enable the filament change feature
Look in file Configuration_adv.h
In file Configuration.h
No customer reviews for the moment.
Metal square bracket specially made to fit 2020...
Upgrade Scalar XL 3D printer Removes the...
Extender wire 4 pins Dupont 20 cm wire length...
This cleaning needle will help you clean up...
This pack contains a box of 6 cleaning drills...
Screw driver with 31 interchangeable tools...
RE-ARM is a 100Mhz, 32-bit ARM controller with...
Metal square bracket specially made to fit 3030...
3D Modular Systems Filament PLA 1.75mm 750gr -...
ADWIRE Filament PLA 1.75mm 1kg - Red