Warning: Last items in stock!
This sensor is to be placed at the entrance of your extruder
The filament has to go through the sensor box
When the filament is running out, the sensor will trigger.
The firmware will then trigger a filament change action
On Rumba boards, you will need to connect the module on AUX3 port on pins PWM_1 et GND
The changes presented here corresponds to Marlin RC8 firmware.
The procedure is similar with other version of marlin that supports this feature. Marlin RC8 and above are available for Scalar 3D printer. You will also find the procedure to upgrade your firmware.
You first need to enable the filament change feature
Look in file Configuration_adv.h
In file Configuration.h
No customer reviews for the moment.
Vibration dampener for Nema 17 Stepper motor...
Strong mechanic Modular chassis Strong and...
1 041,66 €
3 pins Female-Male extender/extension wire 1...
Silicone sock for new E3DV6 heater block only...
arduino Mega 2560 Shield Daughter board...
Key features: Dual Drive System The bed will...
Hot end nozzle of 3D printers: Threading: M6...
Heatbed Pack for Scalar L 3D printer Contains:...
Ceramic screw diver. Great tool to adjust...
Geniun Antclab BLTouch Auto bed leveling probe...