This product is no longer in stock
Warning: Last items in stock!
Titan extruder gives a high level of performances, it's lightweight, and compatible with any hotends with E3D mounting groove (direct or bowden)
Designed by E3D - It's a clone
The extruder has a 3:1 reduction ration,and a cnc machined extrusion gear. THis allows a compact and powerfull extrusion.
This reduction ratio allows the extrusion motor to be less powerfull has the required torq is lower. This allows direct drive systems to be ligther. In case of bowden systems, you will get better extrusion management.
This extruder is compatible with the whole E3D ecosystem (with both 1.75mm and 3mm filament).
Passing from 1.75 to 3mm filament is made changing the inside filament guide.
(Note: this model provides the fitting for 1.75mm only!)
The 3:1 gear ration is a good compromise between speed and torq, allowing to significantly gain in extrusion resolution, and keep maximal extrusion speeds.
Direct drives extruders can suffer from actefacts in pulse mode.
This is induced by low extrusion resolution requiring small motor mouvements. This can lead to artecfact often when using very low layer heights.
Using the 3:1 gear ration tripples the extrusion resolution and allows a nicer finish for low layer heights.
The filament is guided all along the extrusion. this allows smooth motion inside hot end.
The extrusion gear allows to print slippery filament such as PEHD, PETG or even nylon.
It also allows printing technical filament with metalic or carbon charge.
Compatible with 1.75mm et 3mm (Note: this model provides the fitting for 1.75mm only!)
A thumb screw allows to adjust the idler tension. More over a graduated marquing allows to easily adjust this pressure.
This allows to adjust the idler tension rapidely depending on the filament type.
A universal mount compatible with Nema 17 motors is available.
Easy to assemble, modular, and compatible with a wide range of 3D printers.
Titan extruder has most of it's parts cnc machines or plastic injected, gibing it a high level of quality.
The extrusion gear has been specially designed in order to maintain a smooth extrusion / retraction of the filament.
The easy access to the extrusion gear allows an easy cleanup of the potential plastic dust.
You can use the big wheel in order to manually push / pull the filament.
TL-Smoother, specially designed to smooth out...
Metal square bracket specially made to fit 3030...
This is an upgrade kit for E3D-V6 hot end It...
Allen screw for 2020 extruson profile: Steel...
3D printer extruder compression spring Length:...
Heatsink for NEMA 17 stepper motors Can easily...
Default 40W 12V Heater cartridge for RepRap...
Aluminium spacer 10mm height Inner diameter:...
Arduino Mega 2560 r3 controler board...
This cleaning needle will help you clean up...