Scalar S Upgrade - Heatbed 220V 250W

KIT_UPGRADE_S-PLATEAU-CHAUFFANT

New product

Upgrade kit for Scalar S Heat bed

This kit contains:

  • 1 Silicone plate, 250W, 220V with power plug (EU type)
  • 1 static relay with a plastic casing
  • 1 temperature sensor (thermistor)
  • 1x 20cm ground wire

More details

In Stock

Warning: Last items in stock!

60,80 € tax incl.

Instead of 60,90 €

Including 0,10 € for ecotax

More info

This kit is great to add a Heat bed to your existing Scalar S 3D printer or any reprap 3D printer with a 20x20cm build platform.

Setup description

  • The heating silicone element is 190x190mm and has a thermal fuse build in that triggers at 140°C
  • The thermistor, is to be stuck under your aluminium plate. It is also to be secured using Kapton or aluminium tape. Make sure to place the tip of the thermistor in the middle of your aluminium plate.
  • The silicone heater is to be stuck under the aluminium plate, over the thermistor.
  • A simple aluminium foil is to be stuck below your silicone heater in order to insulate the whole system. Do not use any other insulator type
  • The static relay has 2 sides. 1 side is to be connected to the 220V heat bed. (double check if this is the proper side). The other side is to be connected to your Ramps electronics on 1 of the blue terminals. Here this side is polarized, so make sure to wire the +12V on the +12V and the Gnd to the ground.
  • The ground wire provided with the silicone heater is to be connected to your chassis.
  • The separate 20Cm ground wire, is to be connected with the ground wire of the silicone heater on 1 side. The other side is to be connected under the metallic par of your heat bed.

Firmware upgrade

For this upgrade you will need to update your firmware in order to enable the heat bed feature.

You will find below the link to the procedure on how to upgrade your firmware, as well as the firmware itself compatible with a heat bed.

doc.3dmodularsystems.com/updatingupgrading-your-3d-printer-firmware/

Not provided in this kit

  • Aluminium plate

Pack content

Reviews

No customer reviews for the moment.

Write a review

Scalar S Upgrade - Heatbed 220V 250W

Scalar S Upgrade - Heatbed 220V 250W

Upgrade kit for Scalar S Heat bed

This kit contains:

  • 1 Silicone plate, 250W, 220V with power plug (EU type)
  • 1 static relay with a plastic casing
  • 1 temperature sensor (thermistor)
  • 1x 20cm ground wire

Accessories