This product is no longer in stock
Warning: Last items in stock!
A pdf3D is available showing the assembly of the aluminum plates and the silicone heater
|Heat Bed support||Yes|
|Print surface material||3mm Aluminum|
|Heat Bed safety thermal fuse||Yes, calibrated to 140°C (284°F)|
|Heat bed power supply voltage||220V AC|
|HeatBed heat time PLA 25°C-60°C (77°F-140°F)||1 minute|
|HeatBed heat time PLA 25°C-110°C (77°F-230°F)||3 minutes|
|Supported plastic types||PLA, ABS, flexibles filament, wood, laybrick, fluorescent, etc....|
|Input Voltage||250V AC|
XL silicone heater for RepRap 3D printers Material: Silicone Size: 400x300mm Power: 700W Input Voltage: 220V Power supply cable length: 1 metre Back Tape: 3M Thermal fuse set at 140°C Can reach 110°C in 3 minutes (tested on Scalar XL with insulators)
Thermistor 100K for 3D printer heatbeds Beta: 3950 1% Resistor: 100K Max temperature: 285°C Compatible with marlin firmware (table #11) 1 meter lead wire wired with 2 pin dupont connector
Pack of 2 aluminum plates 3mm/2mm thick Laser cut 1 top plate (print surface) 435x320x3mm with 4 holes in the corners for screws1 bottom plate 435x320x2mm with 4 holes in the corners for screws 10 holes for bearing and belt supports
No customer reviews for the moment.
Heatsink specilly made for stepper drivers such...
This pololu A4988 stepper motor driver is...
Special belt tensioner spring Compatible with...
WhitePTFE tube for 3D printer filament This...
Twin Wire 24 AWG (diametre 0.5106mm, area...
Axial ball bearing 608Z 8mm x 22mm x 7mm
The lightest performing extruder on the market...
Dupont crimps for Dupont housing connector
MK8 Direct Drive extruder wheel Inner...